Moen MT138A Manuel d'utilisateur télécharger pdf

MT138A

INSTALLATION INSTRUCTIONS

LAVATORY FAUCETS

Four-Inch Centerset

6" X 2" WIDE

1/2" IPS

THREADED

CONNECTIONS

LIFT ROD

POSITION

USE SPACER TO INSTALL

ON THINNER LAVATORY

BOWLS OR COUNTERS

DISCARD SPACER WHEN

INSTALLING ON THICKER

LAVATORY BOWLS OR COUNTERS

1-3/4"

MAX.

4-3/4"

3-5/8" C.C.

1-3/4"

5" NOMINAL

OPEN

POSITION

5" NOMINAL

OPEN

POSITION

CONCENTRIX HANDLE

CONCENTRIX

HANDLE INSERT

3-5/8" C.C.

1-3/4"

3-5/8" C.C.

1-3/4"

5" NOMINAL

OPEN

POSITION

LEVER HANDLE KNOB HANDLE

With clamp bar, spacer and

mounting nut installed, tilt

clamp bar back as shown,

then drop faucet supplies

down through deck holes and

tighten from below. On decks

thicker than 3/4" you may

have to remove spacer.

Fits 4" centers and through a 1" minimum diameter hole.

All models equipped with a Moen Flow-Rator™.

TILT BACK

CLAMP BAR

8410, 8415, 8416, 8450, 8455

Always turn water off before disassembling the valve. Open valve handle to alleviate

water pressure to insure that complete water shut-off has been accomplished.

Before turning water on during either rough-in or trim-out, make sure that the cartridge retainer clip is in place. The cartridge

and retainer clip were properly installed and tested before leaving the factory. Although it is unlikely, it is nevertheless possible

that through the handling of the valve by any number of persons the retainer clip may not be properly installed. This should

be carefully checked at time of rough-in and trim-out. If the retainer clip is not properly installed, water pressure could force

the cartridge out of the casting. Personal injury or water damage to the premises could result.

CAUTION:

CLIP

EAR

Complies with ASME A112.18.1M and CSA B125

1 2 3 4

Résumé du contenu

Page 1 - LAVATORY FAUCETS

MT138AINSTALLATION INSTRUCTIONSLAVATORY FAUCETSFour-Inch Centerset6" X 2" WIDE1/2" IPSTHREADEDCONNECTIONSLIFT RODPOSITIONUSE SPACER TO

Page 2 - IMPORTANT:

FAUCETCONNECTIONNIPPLETIGHTENNUTHOLD WITHWRENCHInstallationBe sure lavatory or mounting surface is clean and dry. Place a bead of plumber's putt

Page 3 - Reassembly

DisassemblyCAUTION: Turn OFF both hot and cold water supplies. Open handle to alleviate water pressure to insure thatcomplete water shut-off has bee

Page 4 - In Canada:

Commentaires sur ces manuels

Pas de commentaire

Moen MT138A Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Articles sanitaires Moen MT138A. Moen MT138A User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Articles sanitaires Moen MT138A