25300 AL MOEN D R I VE N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321-8809 F AX: (800) 848-6636
I N TER N ATI ON AL: (440) 962 -2000 F AX: (440) 962-2726
C U STOMER SER VI C E (U SA): 800-882-0116 FAX: (888) 379-2720
W W W . MOEN . C OM
Copyright Creative Specialties International Literature # BA1518
Pivoting Paper Holder post is die
cast from highest quality zinc alloy
(Zamac). Casting is plated in chrome,
brushed nickel or oil rubbed bronze.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting post location that
corresponds to your product.
4. Remove the template from the wall.
5. Fold ends of the plastic toggle together and insert into each hole
in the wall.
6. Lightly tap anchors until flush with the wall.
7. One at a time, insert plastic pin into each of the anchors and
lightly tap to activate anchor. Remove pin and repeat on all
anchors.
8. Remove mounting posts from the product assemblies by
loosening each setscrew.
9. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
10. Insert screws through the mounting plate into the anchors. Tighten
the screws.
11. Place each assembly over the mounting posts with setscrews
facing down. Pivoting post with bar should be on the left side.
Tighten both setscrews.
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.
Commentaires sur ces manuels