(.040) type 304 stainless steel tubing.
q
Brushed Nickel Finish, 1 ¼” Bar,
Concealed Screw Mounting
q LR8724D2BN – 24” Elite Grab Bar
Brushed Nickel Finish, 1 ¼” Bar,
Concealed Screw Mounting
q LR8716D2CH – 16” Elite Grab Bar
Chrome Finish, 1 ¼” Bar,
Concealed Screw Mounting
q LR8724D2CH – 16” Elite Grab Bar
Chrome Finish, 1 ¼” Bar,
Concealed Screw Mounting
1.
Please note that screws MUST be mounted into a wood stud for secure installation.
2. Slide the decorative cover away from the hub end to expose the SecureMount™
mounting flange. Do not remove protective plastic from decorative cover until
indicated later in these instructions.
3. Locate the studs behind the wall by using a stud sensor or other stud locating
method. Studs are usually 16 in. apart; locate the center of each stud.
4. Moving aside the decorative cover as needed, with a pencil, mark three of the
mounting locations on each of the two grab bar flanges. Two marks to be made
above the grab bar in the area indicated in the illustration below. The third mark
to be made below the grab bar in the area indicated in the illustration below.
Decide whether you would like to position your grab bar horizontally, vertically or
at an angle, remembering that BOTH ends of the grab bar MUST be positioned
over a wood stud.
5.
Moving the decorative cover as far away from the marked slots as possible, drill a
hole into the marks, through the slots (as shown in illustration). Position the drill
at a slight angle in order to get around the gr
ab bar and decorative cover, making
sure to drill into the wood stud. If desired, apply silicone caulk to the back of the
decorative cover to guard against water penetration.
6. To mount the grab bar, reposition one end of the grab bar SecureMount™
mounting flange over the marked holes.
7.
Thread a washer onto each screw. Using the screwdriver, screw the wood screws
with washers into the SecureMount™ mounting flange at one end of the grab bar.
Then screw the wood screws with washers into the mounting flange at the other
end of the grab bar.
8. Tighten the screws until secure.
9. Slide the decorative cover over the SecureMount™ mounting flange, rotating to
find the correct fit before snapping into place.
Slide decorative covers over SecureMount™ mounting flanges.
_________________________
By Creative Specialties
Installation Instructions:
Stock Numbers:
Elite Grab Bar
Home Care Technical Specification
25300 AL MOEN DRIVE
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: (800) 848- 6636
INTERNATIONAL: (440) 962- 2000 • FAX: (440) 962-2726
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: (888) 379-2720
Copyright Creative Specialties International 2005
16" Grab Bar 24" Grab Bar
A 16.00 24.00
B 19.15 27.15
C 3.15 3.15
D 2.80 2.80
E 1.50 1.50
(1 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels